Grand to Grand Technical Services Co offers washing machine repair (تصليح غسالات) in Dubai for front-load, top-load and washer-dryer machines from every major brand. When a machine won’t spin, drain or start, our certified, in-house technicians find the real fault and fix it at your home, usually the same day. Any part we replace carries a 30-day warranty.
Washing machine repair at a glance
- Arrival: same day for most faults
- On-site time: most home repairs take 1 to 2 hours
- Visit and diagnosis: AED 100–150, depending on distance (waived if you go ahead with the repair)
- Price: fixed and itemised before any work starts
- Warranty: 30 days on every part we replace
- Machines: front-load, top-load and washer-dryers, home and commercial
Common Washing Machine Problems We Fix
These are the faults we see most in Dubai homes, and what usually causes them:
Washing machine not spinning, or clothes still soaking wet
Usually a worn or snapped drive belt, a seized drum bearing or a failed motor. On front-loaders, a faulty door interlock can stop the spin. An unbalanced load can also make the machine cut the spin short to protect itself.
Not draining, or water left in the drum
Most often a drain pump filter blocked with coins, hair clips or fluff, a kinked or blocked drain hose, or a drain pump that has burnt out.
Water leaking onto the floor
Often a worn door seal (gasket), a loose or cracked hose, a leaking pump, or a blocked detergent drawer overflowing. A cracked drum or tub is rarer but does happen.
If water is still coming out, turn off the tap behind the machine and call our 24/7 emergency repair line.
Machine won’t start or is completely dead
A blown thermal fuse, a faulty lid switch on top-loaders, a door lock that isn’t engaging, or a damaged control board. Power surges in older buildings are a common cause of board failure.
Loud banging, shaking or walking across the floor
Worn shock absorbers or springs, damaged drum bearings, a machine that isn’t level, or transit bolts left in a newly installed machine. A grinding or rumbling noise on spin usually means the bearings are going.
Door won’t open, or won’t lock
A failed door interlock, or water still in the drum because the machine hasn’t drained. Don’t force the door: it can break the handle or the lock and make the repair bigger.
Not filling with water
A faulty water inlet valve, a blocked filter screen where the hose connects, a closed or half-open tap, or low water pressure in the building.
Bad smell from the drum or door seal
Mould and bacteria growing in the rubber door seal, the drum and the detergent drawer. Dubai’s humidity makes this much more common in front-loaders.
Detergent left in the drawer
A blocked dispenser drawer or a failed dispenser valve, often from hard-water scale and detergent build-up.
Samsung, LG, Bosch and Siemens Washing Machine Repair
Samsung (سامسونج), LG (إل جي), Bosch (بوش) and Siemens (سيمنس) make up most of the machines we repair in Dubai. If your machine shows an error code, send us a photo of the display on WhatsApp. It helps the technician bring the right part. Codes vary by model, but these are the ones we see most:
Samsung washing machine repair
- 4C or 4E: no water coming in (tap, inlet hose filter or inlet valve)
- 5C or 5E: not draining (pump filter, drain hose or drain pump)
- UB, UE or Ub: unbalanced load, or worn shock absorbers if it keeps happening
- dC or dE: door not closing or locking
LG washing machine repair
- IE: water not filling
- OE: water not draining
- UE: unbalanced drum
- dE: door lock fault
- LE: motor locked or motor fault
- PE: water level (pressure) sensor fault
Bosch and Siemens washing machine repair
Bosch and Siemens machines are made by the same company and share many parts and codes:
- E17 or F17: water takes too long to fill
- E18 or F18: water not draining
- F21: motor or drum problem, often a blocked drum or worn motor brushes
- E23: water detected in the base (AquaStop leak protection)
Don’t keep resetting a machine to clear a code. The fault behind it is still there and can get worse.
What Our Washing Machine Repair Covers
- Drive belt, drum bearing and motor replacement
- Drain pump and filter clearing or replacement
- Water inlet valve and hose repair
- Door seal, latch and interlock replacement (front-loaders)
- Lid switch and agitator repair (top-loaders)
- Heating element and thermostat replacement
- Control board (PCB) diagnosis and replacement
- Shock absorber and spring replacement
- Error code diagnosis on digital and smart models

Front-Load, Top-Load and Washer-Dryers
- Front-load machines: the most common type in Dubai apartments. Door seals, door locks, bearings and drain pumps are the usual repairs.
- Top-load machines: lid switches, agitators, drive belts and suspension springs.
- Washer-dryers: we repair both the washing and drying side. Separate tumble dryers are covered by our dryer repair service.
- Built-in and integrated machines: repaired in place where there’s enough access.
Why Washing Machines Wear Out Faster in Dubai
- Hard water. Dubai’s tap water carries a lot of calcium and magnesium. Scale builds up on the heating element, in the inlet valve and around the drum. A scaled element works harder, uses more power and eventually burns out, and a partly blocked valve causes fill errors.
- Humidity. Moisture stays inside the machine after every wash, so mould grows quickly in the folds of the door seal. Once it gets into the rubber, the seal usually has to be replaced, not just cleaned.
- Heavy use. Large families and shared apartments often run three or more loads a day. Bearings, belts, motor brushes and shock absorbers are built for a set number of cycles, so they wear out years early. We regularly see failed bearings in machines that are only a few years old.
- Voltage spikes. In older buildings, an unstable supply can damage the control board. What could have been a small repair becomes a board replacement.
Quick Checks Before You Call
Some problems have simple causes. These checks are safe to try:
- Make sure the water tap behind the machine is fully open and the inlet hose isn’t bent.
- Check the child lock isn’t on, and the door is pushed fully shut.
- Turn the machine off at the plug for 5 minutes, then try again.
- If it won’t drain, place towels down and clean the small pump filter at the bottom front (check your manual first).
- For shaking, check the machine is level and the load isn’t one heavy item like a bath mat.
If none of that works, or you smell burning or see water near the plug, switch it off and call us.
How Much Does Washing Machine Repair Cost in Dubai?
The visit and diagnosis charge is AED 100–150, depending on distance (waived if you go ahead with the repair). After checking the machine, the technician gives you a fixed, itemised price. Clearing a blocked pump or replacing a belt or door seal costs much less than replacing bearings, a motor or a control board.
Repair or replace? If one part has failed and the machine is otherwise in good condition, repair is almost always cheaper, even on a machine over 5 years old. If the drum bearings have gone on an older machine with a sealed tub, or several parts are failing at once, a new machine can be the better buy. We’ll tell you honestly before any work starts.
For Homes and Businesses
At home, a broken washing machine throws the whole week out, especially for big families. Our technicians carry the parts most often needed for Samsung, LG, Bosch and Whirlpool (ويرلبول), the brands we see most in Dubai apartments, so most home repairs are done in one visit without moving the machine.
Hotels, hotel apartments, laundries, salons, clinics and building managers get a priority response. We work on commercial machines from brands including Miele Professional, Electrolux Professional and Primus through our commercial appliance repair service.
Brands We Repair
Samsung · LG · Bosch · Siemens · Whirlpool · Miele · Electrolux · Beko · Ariston · Haier · Candy · AEG · Zanussi · Indesit · Midea · Panasonic · Toshiba, plus older and less common makes. Not sure about yours? Send a photo of the label. Our brands we repair page has the full list.
Why Choose Us
- Same-day repair for most faults, and open 24 hours
- Certified in-house technicians: no subcontractors
- Genuine or OEM-equivalent parts only
- Fixed price before work starts, with no hidden charges
- 30-day parts warranty: if a part we fitted fails within 30 days, we replace it free. Only the labour for that visit is charged.
Areas We Cover
We’re based in Al Khabaisi, Deira, so we reach Al Rigga, Hor Al Anz, Al Muraqqabat, Port Saeed and Al Qusais fastest, and cover the rest of Dubai every day, including Al Nahda, International City, Al Barsha, JLT, Discovery Gardens and Dubai Silicon Oasis. Our Dubai service areas page lists every area we cover.
What Our Customers Say on Google
Washing Machine Repair FAQs
How much does washing machine repair cost in Dubai?
There is a visit and diagnosis charge of AED 100–150, depending on distance (waived if you go ahead with the repair). After diagnosis you get a fixed, itemised price before any work starts. The cost depends on the part: clearing a pump or replacing a belt or seal costs much less than bearings, a motor or a control board.
Why is my washing machine spinning but clothes are still soaking wet?
The drum isn’t reaching full spin speed. Common causes are a slipping drive belt, a worn bearing, an unbalanced load making the machine cut the spin short, or on front-loaders a faulty door interlock. A technician can usually confirm and fix it on the same visit.
Why is my washing machine not draining?
Most often the small drain pump filter is blocked with coins, hair clips or fluff, or the drain hose is kinked. If clearing those doesn’t help, the drain pump itself has probably failed and needs replacing.
My washing machine shows an error code. What should I do?
Note the code or send us a photo of the display. Each code points to a specific fault, such as drain, water supply, door or board. Don’t keep resetting the machine to clear it, because the fault is still there and can get worse.
Why does my front-loading washing machine smell bad?
Mould is growing in the rubber door seal, the drum or the detergent drawer. Dubai’s humidity keeps the machine damp between washes. Leave the door and drawer open after each wash. If the mould has got into the seal, it will need a professional clean or a new seal.
How does Dubai’s hard water affect my washing machine?
Minerals in the water build up as scale on the heating element, drum and inlet valve. Over time this lowers washing performance, raises power use and can block the water inlet or burn out the heater. Descaling the machine regularly helps protect it.
Is it worth repairing a washing machine that is more than 5 years old?
Usually yes, if only one part has failed and the rest of the machine is in good condition. If several parts are failing or the bearings have gone on an older machine, replacing it may be better value. We’ll give you an honest view before any work starts.
Is there a warranty on washing machine repairs?
Yes. Every part we replace has a 30-day warranty. If that part fails within 30 days, we replace it free of charge. Labour for the return visit is charged at our normal rate.
Washing Machine Stopped Mid-Cycle? We Can Help Today
Tell us the brand, the problem and your area, and we’ll send a technician, usually the same day.

